Official Wishlist

This is a list of new features for the firmware of the LXR wished by members of the forum.

VOICE (Voice Mode)

• Select pattern in voice mode

PERF, PATGEN (Performance Mode, Pattern Generator)

• Solo voice in performance mode
• new playback modes for the sequencer like forward, backward, random, ping-pong,...

STEP

• Add 'copy step' function

LOAD/SAVE, MENU

• Change letter input when saving -> first letters and numbers and followed by all the symbols no one uses

OSC

• Make Kick Oscillator's frequency range from to 0-127 HZ, value of zero effectively mutes the oscillator.

AEG

• faster/better envelopes with more control in the short range.
• replace Decay with 'Length' property (determines total duration from initial trigger until fade out, decay (release) is sorted by subtracting Attack from Length)
• Attack ramps all the way to the maximum volume level before the Decay (Release) portion starts.
• Slope Type(s) 4 modes: fast attack fast decay, fast attack slow decay, slow attack fast decay, slow attack slow decay (perhaps this can be a continuous morphing parameter)

MOD

• add Attack parameter to envelope (in milliseconds)
• add Hold parameter to envelope (in milliseconds)
• add a new envelope specifically for FM

FM

• Ratio or Frequency toggle, with coarse and fine control where possible.

CLICK

• Correct names for the transient parameters in "click"
• Put user samples in here also (or instead of in OSC)
• sometimes the Click is a bit weak (see MIX)
• Add filters and resonance in transient generator menu

FILTER

• tilt filter

LFO

• LFO rate -> extra divisions like 1 1/2, 3, 6 and 8
• Add transient generator parameters to lfo destination

MIX

• there is a pattern length parameter in the mixer section, it would be handy to also have a reset parameter. For instance when you have a track set to 14 steps and reset at 32 steps it plays 2x14 + 4 steps and then resets to the first step of the sequence.
• add OSC/Click mix parameter O/C

Trigger Extension

• More clock multipliers like 2/1 (double tempo) or even slower than the original speed like 1/2 (half tempo) and so on

DRUM 1-3

• Change frequency range to 0-127 HZ, zero mutes the oscillator

SNARE

• independent envelope length for OSC and Noise
• Mix between Snare and Click
• Pseudo-Delay by adding length (time between two repeats) and feedback (factor between 0-1 being multiplied for each repeat) to the repeat function